Produse pentru căldură pvc (5)

Biobasierte, nitrit- und aminfreie korrosionshemmende Verpackungsfolie Die nächste Generation umweltfreundlicher, nitritfreier VCI Folien. Innovative Korrosionsschutzfolie überzeugt durch die Kombination aus maximalen Rostschutz aus umweltreundlichen Bestandteilen, überragenden mechanischen Eigenschaften und schonender Anwendung.

Schraubensicherungslack (Plombierungsicherung) in unterschiedlichen Farben und Lösungsmittelhaltig für ein sicheres Sichern und Siegeln von Schrauben. Erhältlich in und 15 ccm und 60 ccm Tuben. Deutschland: 21,50 €

Properties: ALDOVET SAN is a special surface disinfectant concentrate on an excellent bactericidal, fungicidal, and virucidal effect. ALDOVET SAN is very well suited for the disinfection of surfaces and equipment in livestock barns, as well as for working surfaces, sanitary facilities, and animal transport vehicles. Application: Only apply on acid-resistant surfaces. Before disinfection, all surfaces must be cleaned thoroughly with suitable cleaning agents for animal houses (e.g. ALDOVET TENS). After the surfaces are cleaned and dried the proper use-solution of ALDOVET SAN is applied with the usual application equipment. Surfaces with animal contact must properly be rinsed with water after disinfection.

In the injection moulding process TPE pellets are fed into the machine through a hopper and then into a heated barrel. The heat from the barrel turns the material into a liquid resin which is then injected into a closed mould under high pressure. After allowing the molten polymer to cool, the finished part can be removed from the mould. Injection moulding is a high-volume, high tooling cost process, the advanced properties of our TPE compounds deliver short cycle times allowing parts to be produced at a rapid rate. The information below is intended as a general overview, settings may vary depending on the specific grade selected. Please CONTACT US for detailed processing information Settings Equipment Conventional injection moulding machine Compression set At least 2:1. Special screws with short sections and higher compression ratios (3:1 to 4:1) may be good at low screw speeds Shrinkage Between 1.0% and 2.5% depending on the grade, type of application and location of the gate. Moul

Common type wires and terminals to simplify earthing scheme organization. Applicable product:Rec15_AI1_5p, Rec25_AI1_5p